Price: P4,500.00 / 1 canisterPHOSTOXIN® tablets and pellets are used to protect stored commodities from dam- age by insects. In limited areas, applications of PHOSTOXIN® may be made to con- trol burrowing vertebrate pests. The use of this product is strictly prohibited on single and multi-family residential properties and nursing homes, schools (except athletic fields), daycare facilities and hospitals. For a list of approved sites see Section 26.1. PHOSTOXIN® metal phosphide fumigants are acted upon by atmospheric moisture to produce phosphine gas.
PHOSTOXIN® tablets and pellets contain aluminum phosphide (AlP) as their active ingredient and will liberate phosphine via the following chemical reaction: AlP + 3H2O —> Al(OH)3 + PH3 Phosphine gas is highly toxic to insects, burrowing pests, humans, and other forms of ani- mal life. In addition to its toxic properties, the gas will corrode certain metals and may ignite spontaneously in air at concentrations above its lower flammable limit of 1.8% v/v (18,000 ppm). These hazards will be described in greater detail later on in this Applicator’s Manual. PHOSTOXIN® also contains ammonium carbamate which liberates ammonia and carbon dioxide as follows: NH2C00NH4 —> 2NH3 + CO2 These gases are essentially non-flammable and act as inerting agents to reduce fire hazards. PHOSTOXIN® is prepared in two spherical shapes. The rounded tablets weigh approximately 3 grams and will release 1 gram of phosphine gas. They are about 16mm in diameter. The pellets are about 10 mm in diameter, weigh approximately 0.6 gram and release 0.2 gram of phosphine gas.
Price: P3,400 1 liter
Price: P4,500 / liter
Is also an effective larvicide. The rate of application will depend on a number of factors including depth of the water, length of persistence required and species to be controlled. Most other mosquitoes larvicides require an increase in dose of up to 10 times when used in polluted or highly organic water. ‘Actellic’ 50EC needs to be applied only at 1.25 times the rate recommended for clean water.
Application Rate For Actellic 50EC Fogging/ULV Aerosol Spray
• Controls adult aedes Spp mosquitoes. • High intrinsic activity. • Effective against other mosquitoes strain. • Control malathion resistant mosquitoes. • Low environmental impact. • Easy to use. • Has both adulticidal and larvicidal properties.
|Method||Dilution||Mixing rate/ application rate||Diluent||g a.i. per area|
|Thermal Fogging||1:25||200ml to 5 litres/5 litres mixture per hectare||Diesel Kerosene||100g a.i./ha|
|ULV Aerosol Spray||1:19||200ml to 4 litres/4 litres per 0.5 hectare or 0.8 ml per m2||Diesel Kerosene Water||100g a.i./ha|
• Controls larvae in both polluted and clean water. • Works very well in water with the presence of decaying organic matter. • Controls both larvae and pupae. • Superior larvicide compared to other organa-phosphorus insecticides.
Recommended Rates:- volume 100/ha Shallow water- 1ml/itre of water (50g a.i./ha) Deep water- 10 ml/litre of water (500g a.i./ha)
Price: P3,888/ literCislin EC is oil-based with good “flushing” action and knockdown effect. It can be used in a wide variety of situations to provide a strong visual effect, as well as good residual control of a variety of insect pests. It is effective in on a variety of surfaces. Cislin EC contains a highly active light stable pyrethroid for effective kill and good residual effect. It is applied as a coarse spray directly onto surfaces, and can be used both indoors and outdoors.
Key Benefits: Flushing action to drive insects out of their harbourages giving a fast action and strong visual effect. A versatile insecticide which enables it to be used in a wide variety of situations. Easy to pour and mix, so it’s easy to use. Provides good residual activity reducing frequency of application. Controls most common insect pests so there’s no need to buy several different products.
Price: P2,800 / liter
It protects all types of wood, sawn timber, bamboo and leadrite-big-new-flat other indigenous material against molds and sapstain fungi that last for a minimum of 3 years. It is biodegradable and is safe to use.It has a unique mode of killing growth inhibiting or fungistatic action. It stops the growth of the fungi, effectively preventing further infection and/or invasion of host tissues.
It is highly compatible to LEADS s Woodtec(EC or RTU) for a complete protection against insect and fungal attack.
Bora Care is mixed 1:1 to 2:1 depending on insect and thickness of wood. Bora-Care works differently than most other insecticides, termiticides and even other borate products on the market today. For starters, it isn’t applied to the soil but to the structure itself. Secondly, it isn’t just a repellent or a bait but a little bit of each. Bora-Care’s unique patented blend of glycols in combination with a borate salt provides results that are hard to beat. As soon as beetles and ants attempt to consume treated wood they die. Subterranean termites won’t even try to eat treated wood and if they attempt to build a tube on treated wood, the termites start to die. This alerts the termite colony and they abandon the wood. Bora-Care is applied directly onto wood surfaces. Bora-Care then penetrates the wood, protecting it throughout. Because the active ingredient in Bora-Care is a mineral salt, it doesn’t break down over time, so it remains in the wood for the life of the wood, providing residual protection. By keeping the wood sealed or protected from moisture as in the wall voids of your home, you eliminate the need for retreatment. Unlike soil treatments, Bora-Care is not pumped into the ground and poses no threat to lakes, rivers, aquifers or the environment. Bora-Care can even be used on lakeside homes where soil termiticides may be prohibited. Bora-Care’s active ingredient is a natural mineral salt called Disodium Octaborate Tetrahydrate (DOT), which contains the element boron. Boron is an element on the periodic table that is already present in the environment – not only in the ecosystems outside of your home – but also in many of the products you use inside such as soaps and cosmetics. Boron is also found in many of the vegetables we eat. BORA CARE Termite Insecticide, Termiticide and Fungicide is a highly effective odorless pesticide which offers an innovative approach for the control and elimination of termites. BORA CARE is an EPA Registered, low toxicity pesticide designed to penetrate and protect all types of wood, including plywood and composites, from infestations of wood boring insects such as termites, Powderpost beetles, carpenter ants and decaying fungi. BORA CARE is designed to treat the termites’ food source – wood and other cellulosic materials. BORACARE works by depositing an active ingredient in the wood which will not decompose or vaporize like many other pesticides. This means that it will keep providing broad spectrum protection with little impact on our environment. In addition, BORACARE provides long term protection (up to 40 years)against future infestations.Odorless concentrate used to prevent or eliminate active infestations of Drywood, Formosan and Subterranean termites. Boracare prevents reinfestation, kills powderpost beetles and their larva,Anobid beetles, Old House Borers and stops Carpenter ant damage. Boracare destroys existing decay fungi and provides protection against reinfestation. Boracare is labeled for use on natural untreated wood.Excellent for pre-construction of decks, fence posts or any other wood surfaces that make contact with the soil. Provides protection for the life of the wood. Indoor and outdoor use. It’s the best insurance you can buy for wood destroying insects and organisms. Bora Care is mixed 1:1 to 2:1 depending on insect and thickness of wood. Boracare Dilution Tables below for more details. . One gallon of Boracare can be sprayed or brushed on and covers from 200-800 sq. ft. Boracare may be used on natural untreated wood.Excellent for pre-construction of decks, fence posts or any other wood surfaces that make contact with the soil. Provides protection for the life of the wood. Indoor and outdoor use. It’s the best insurance you can buy for wood destroying insects and organisms. DILUTION RATIOS by volume TABLE A. Dilution Ratios Water to Target Pests BORA-CARE Application Notes All Insects and Decay Fungi 1:1 Spray, Injection, Brush, Roller Subterranean and Formosan Termites 1:1 or 2:1 2:1 dilution ratio may be used for foaming Drywood Termites 1:1 or 2:1 Anobiid and Lyctid Powderpost Beetles 1:1 or 2:1 Use a 2:1 dilution ratio for treating hardwood floors. Logs require a 1:1 ratio. All other beetle species 1:1 Carpenter Ants 1:1 or 2:1 Decay Fungi 1:1 or 2:1 Use a 1:1 dilution ratio on wood members 2″ thick or greater. Drywood Termites, Powderpost Beetles and Decay Fungi 5:1 Two (2) applications required for surface spray. For prevention only. TABLE B. Application Dilution Ratios Water to BORA-CARE® Application Notes Logs, Large Beams and Dimensional Lumber 1:1 All Insects and Decay Fungi. Preventative Treatment of Decking, Fences and Plywood 2:1 Use on wood members 2″ in thickness or less. Prevention of Powderpost Beetles and Drywood Termites 5:1 For prevention only. Logs, Large Beams and Dimensional Lumber 5:1 Dip treatment only.